Hawken fullstock, pre shaped stock, non-inlet, 15/16", or 1" octagon 38" barrel
Shaped but not mortised for a lock, this Hawken fullstock is modeled after the early work of Jacob and Samuel Hawken, with an early square cheekpiece, not the later beavertail found on halfstocks. We strongly recommend straight grain maple for large bores. Shaped for a right hand shooter, with 15/16”, or 1" straight octagon barrel channel. The stock will accept barrels up to 38" in length. All 15/16" stocks have 3/8” ramrod hole drilled full depth, while 1" have a 7/16" ramrod hole drilled full depth. The forend is shaped on all stocks. The buttplate is uncut. Order our fullstock Hawken plans to help layout and design this project.
Drop is about 3-1/2” from the line of sights. The stock is not cut for a buttplate, so you may adjust the trigger reach, up to about 15” length. The butt end is about 4-15/16” x 1-5/16”, for our early wide Hawken buttplate. Lock panels are shaped, with no lock mortise cut, hand inlet your flint or percussion lock. Not cut for the tang hand inlet a long Hawken hooked breech, straight, flared, or your own custom shaped breech plug. Not inlet for a specific trigger, hand inlet your favorite single or set trigger in this nice stock.
Specifications for non-inlet stocks:
Drop and trigger reach: drop is 3-1/2" from the line of sights to heel, at 15" of pull
Barrel channel size: 15/16", 1" straight octagon, up to 38" length
Butt end: 1-5/16" wide by 4-15/16" high, not cut for buttplate
Lock & Trigger: uncut
Ramrod hole & groove: 3/8" diameter for 15/16", 7/16" diameter for 1", drilled full depth
